How to Use a Needle Inserter and Threader on Any Sewing Machine

Quick Answer

The MadamSew Ultimate Needle Threader combines a needle holder and a threader in one tool, letting you change and thread a sewing machine needle without straining your eyes or hands.

Step-by-Step Guide

1. Step 1: Remove the Old Needle: Loosen the needle clamp screw on your sewing machine. Use the needle holder side of the MadamSew Ultimate Needle Threader to grip the old needle firmly. Pull the needle downward and out. Set the old needle aside safely. Common mistake: Forgetting to turn off the machine or remove the power cord. Always unplug first.
2. Step 2: Insert the New Needle: Hold the new needle with the flat side facing the back of the machine (check your machine manual if unsure). Use the needle holder to grip the needle shaft and push it up into the clamp as far as it will go. Tighten the screw securely. Checkpoint: The needle should not wobble. If it does, the flat side may be facing the wrong direction.
3. Step 3: Prepare the Thread: Cut the thread end at a 45-degree angle with sharp scissors. Dampen the tip slightly to prevent fraying. This makes it easier to guide into the threader.
4. Step 4: Thread the Needle: Flip the MadamSew Ultimate Needle Threader to the threader side. Insert the fine wire loop through the needle eye from front to back. Place the thread end into the loop, then gently pull the loop back through the eye, bringing the thread with it. Common mistake: Pulling the loop too hard or at an angle can bend it. Pull straight and slowly.
5. Step 5: Secure the Thread: Pull about 4-6 inches of thread through the needle eye. Guide the thread under the presser foot and toward the back of the machine. Lower the presser foot and you're ready to sew. Checkpoint: Always raise the presser foot before threading to allow the thread to seat properly in the tension discs.

Product Facts

• Needle Inserter and Threader for Sewing Machines: The MadamSew Ultimate Needle Threader has a needle holder on one side to change your sewing machine needle and a pin on the other side that pushes the thread through the eye of the needle. This two-in-one design means you don't need separate tools for needle changes and threading, saving time and reducing hand strain.